Hyundai Tucson: Clutch System / Clutch Master Cylinder Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Clutch System / Clutch System / Clutch Master Cylinder Repair procedures

Removal

Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1.	Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer (B).

2.	Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

3.	Remove the clutch master cylinder by turning it clockwise (A).

Installation

Installation is the reverse of removal.

•	Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid. (Refer to "clutch release cylinder" in CH group.)

Clutch Master Cylinder Components and Components Location

Components 1. Reverse hose2. Master cylinder3. Siller4. Member assembly5. Turn over spring6. Clutch switch7. Clutch arm8. Pedal pad9. Ignition lock switch10. Stopper ...

Clutch Release Cylinder Components and Components Location

Components 1. Union bolt2. Gasket3. Tube joint4. Clutch tube5. Valve plate6. Valve spring7. Bleeder screw8. Release cylinder9. Return spring10. Piston11. Boot12. Push rod ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Battery Specifications
Specifications Battery ItemSpecificationModel typeCMF68L-BCICapacity [20HR / 5HR] (AH)68 / 54 Cold Cranking Amperage (A)600 (SAE) / 480 (EN)Reserve Capacity (Min)113 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Passive Occupant Detection System (PODS) Components and Components Location
Components 1. Sensor mat2. PODS Uint ...