Hyundai Tucson: Normal maintenance schedule / 60,000 miles (96,000 km) or 48 months
- Rotating tires
- Inspect vacuum hose
- Inspect air conditioning refrigerant
- Inspect brake hoses and lines
- Inspect drive shafts and boots
- Inspect exhaust pipe and muffler
- Inspect front brake disc/pads, calipers
- Inspect propeller shaft (AWD)
- Inspect rear brake disc/pads
- Inspect steering gear box, linkage & boots/lower arm ball joint, upper arm
ball joint
- Inspect suspension mounting bolts
- Inspect brake fluid
- Inspect fuel filter *2
- Inspect fuel lines, fuel hoses and connections
- Inspect fuel tank air filter *2
- Inspect parking brake
- Inspect vapor hose and fuel filler cap, fuel tank
- Inspect valve clearance (for Theta II 2.4) *4
- Inspect drive belts (First, 60,000 miles (96,000 km) or 72 months after
every 15,000 miles (24,000 km) or 24 months) *5
- Replace climate control air filter (for evaporator and blower unit)
- Replace air cleaner filter
- Replace engine oil and filter (60,000 miles (96,000 km) or 96 months)
- Add fuel additive *1 (60,000 miles (96,000 km) or 96 months)
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (52,500 miles (84,000 km) or 84 months)
Add fuel additive *1 (52,500 miles (84,000 km) or 84 mont ...
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (67,500 miles (108,000 km) or 108 months)
Add fuel additive *1 (67,500 miles (108,000 km) or 108 ...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Air cleaner
Filter replacement
The air cleaner filter can be cleaned for inspection using compressed air.
Do not attempt to wash or to rinse it, as water will damage the filter. If soiled,
the air cleaner filter must be replaced.
1. Loosen the air cleaner cover attaching clips and open the cover.
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Cluster Ion Generator Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ion generator fault
* Diagnostic procedure refer to DTC code.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove ...