Hyundai Tucson: Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.

   
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the light switch connector (A) and the wiper switch connector (B).
[LHD]

[RHD]

[LHD]

[RHD]

4.
Remove the wiper switch (A) by pushing the lock pin (B).
   
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

Installation
1.
Install the multifunction switch.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.
[LHD]

[RHD]

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Components and Components Location
Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor (Front)6. Washer reservoir7. Wash ...

Front Wiper Motor Components and Components Location
Component Location 1. Cap2. Nut3. Wiper arm & blade4. Retainer5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Clutch Release Cylinder Repair procedures
Removal 1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing thd tube (B) and bolts (A-2ea). Installation 1. Installation is the reverse of removal.     Coat the clutch clevis push rod specified grea ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Relay Box (Passenger Compartment) Repair procedures
Inspection Fuse 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correctx 3. Are there any blown fusesx If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why ...

© 2010-2024 www.htmanual.net