Hyundai Tucson: Power Door Locks / Power Door Lock Actuators Repair procedures

Inspection
Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
(Refer to the BD group - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
[Central Lock]

[Dead Lock]

Rear Door Lock Actuator
1.
Remove the rear door trim.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
(Refer to the BD group - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
[Central Lock]

[Dead Lock]

Liftgate Lock Actuator Inspection
1.
Remove the liftgate trim.
(Refer to the BD group - "Liftgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Front Door Lock Switch
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
Remove the front door module.
(Refer to the BD group - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
[Central Lock]

[Dead Lock]

Rear Door Lock Switch
1.
Remove the rear door trim.
(Refer to the BD group - "Rear door")
2.
Remove the rear door module.
(Refer to the BD group - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position according to the table.
[Central Lock]

Liftgate Switch
1.
Remove the liftgate trim.
(Refer to the BD group - "Liftgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check for continuity between the terminals in each switch position according to the table.

Components and Components Location
Component Location 1. Driver power window switch2. Assist power window switch3. SJB (Smart Junction Box)4. Door lock switch5. Liftgate lock actuator & switch6. Front door lock actuator & ...

Power Door Lock Switch Repair procedures
Removal Driver Power Window Switch 1. Disconnect the negative battery terminal. 2. Remove the front door trim. (Refer to the BD group - "Front door") 3. Remove the screws from power wind ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description The SMART KEY system is a system that allows the user to access and operate a vehicle in a very convenient way. To access the vehicle, no traditional key or remote control unit is needed. The user carries a SMART KEY FOB which does not require any conscious actions by the user ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Manual adjustment
Forward and rearward adjustment To move the seat forward or rearward: 1. Pull up the seat slide adjustment lever and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. Move forward and rearward without using the lever. If ...

© 2010-2024 www.htmanual.net