Hyundai Tucson: Cooling System / Water Temperature Control Assembly Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation
1.
Drain engine coolant so its level is below water temperature control assembly.
2.
Remove the air cleaner assembly.
(Refer to Engine transaxle assembly in this group)
3.
Disconnect the radiator upper hose (A).

4.
Disconnect the heater hose (A).

   
When installing the heater hoses, install as shown in illustrations.

5.
Disconnect the bypass hose (A) and the throttle body coolant hose (B).

6.
Remove the water temperature control assembly (A) with the O-ring (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Installation is reverse order of removal.
   
•
Install a new O-ring.
•
Clean surface on the O-ring and install the O-ring after wetting with water.
Thermostat Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Retighten the bo ...

Lubrication System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Front Washer Motor Repair procedures
Inspection Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter. 2. C ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module. Installation 1. Install in the revers ...

© 2010-2024 www.htmanual.net