General |
1. |
Basically, all measurements in this manual are taken with a tracking gauge. |
2. |
When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
3. |
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
Measurement Method |
Projected Dimensions |
1. |
These are the dimensions measured when the measurement
points are projected into the reference plane, and are the reference
dimensions used for body alterations. |
2. |
If the length of the tracking gauge probes is adjustable,
make the measurement by lengthening one probe by the amount equivalent
to the difference in height of the two surfaces. |
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use if a
tracking gauge is used for measurement. |
2. |
Measure by first adjusting both probes to the same length (A=A').
|
Measurement Point |
1. |
Measurements should be taken at the hole center. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications
ItemSpecificationsTransmission typeA6MF1Engine modelGasoline 2.0 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeO236 mm (9.2913 in.)Oil pump systemParachoidFriction elementsClutch: 2EABrake: 3EAOWC : 1EAPlanetary gear 3EAGear ration1st4.1622nd2. ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location
1. Slide motor2. Rear height motor3. Reclining motor4. Power seat switch5. Reclining switch6. Lumbar support switch7. Lumbar support motor
...