Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the HO2S connector. |
3. |
Measure resistance between the HO2S terminals 2 and 5 [B1/S1]. |
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. |
5. |
Check that the resistance is within the specification.
|
Removal |
[Bank 1 / Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the connector (A), and then remove the sensor (B).
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the console side cover (A). |
3. |
Disconnect the connector (A), and then remove the sensor (B).
|
Installation |
|
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of
On Board Diagnostics (OBD) for vehicles sold in California beginning
with the 1988 model year. The first phase, OBD-I, required monitoring of
the fuel metering system, Exhaust Gas Recirculation (EGR) sy ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Inhibitor Switch Description and Operation
Description
Inhibiter Switch contains two contact points. One of these
points connects the engine startup when the lever is in the N or P
position and turns on the reverse lights. The other contact point
monitors the lever's position (PRND) and is used to control gear setting
signals. ...