Inspection |
1. |
Ignition "ON" |
2. |
2. Manually operate the control switch and measure the voltage of blower motor. |
3. |
Select the control switch to raise voltage until high speed.
Specification
*AUTO COOLING: Auto speed (4.5V~B+)
*AUTO HEATING: Auto speed (4.5V~11.0V) |
4. |
If the measured voltage is not specification, substitute with a known-good power mosfet and check for proper operation. |
5. |
If the problem is corrected, replace the power mosfet. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws. |
3. |
Install in the reverse order of removal. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting
Ignition System
SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK) Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requi ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Clutch Release Cylinder Repair procedures
Removal
1.
Drain the brake fluid through the bleed plug (A).
2.
Remove the clutch release cylinder assembly (C) after removing thd tube (B) and bolts (A-2ea).
Installation
1.
Installation is the reverse of removal.
Coat the clutch clevis push rod specified grea ...