Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner") |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
4. |
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
|
5. |
Disconnect the air breather hose (A) from the valve body cover after disconnecting the clamp (B). |
6. |
Remove the valve body cover (A).
|
7. |
Remove the bolts. |
8. |
Disconnect the solenoid valve connector (B) and the oil temperature sensor (A) from the valve body.
|
9. |
Remove the solenoid valve support bracket (A).
|
10. |
Remove the torque converter control solenoid valve (A). |
Installation |
1. |
Installation is the reverse of removal.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Owner’s Handbook & Warranty
Information booklet in your vehicle.
Your vehicle is equipped with an emission control system to meet all applicable
emi ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Injector Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
...