Kia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures

Third generation SL (2010Ц2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS): Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to УWave FormФ

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A).

3.
Remove the protector (A).

4.
Remove the installation bolt (A), and then remove the crankshaft position sensor.

Installation
   
Х
Install the component with the specified torques.
Х
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
Х
Apply the engine oil to the O-ring.
   
Х
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.

Crankshaft position sensor installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Crankshaft Position Sensor (CKPS): Schematic Diagrams
Circuit Diagram ...

Camshaft Position Sensor (CMPS): Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Other Information:

Components and Components Location
Components Location 1. Engine Control Module (ECM)2. Manifold Absolute Pressure Sensor (MAPS) #13. Intake Air Temperature Sensor (IATS)4. Manifold Absolute Pressure Sensor (MAPS) #25. Engine Coo ...

Torque Converter Control Solenoid Valve (T/CON_VFS): Specifications
Specifications Direct control VFS[T/CON] ? Control type : Normal low type Control Pressure kpa (kgf/cm?, psi)9.81 ~ 500.14(0.1 ~ 5.1,1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal resist ...

Categories

Copyright © www.htmanual.net 2014-2018