Hyundai Tucson: Intake And Exhaust System / Exhaust Manifold Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / Intake And Exhaust System / Exhaust Manifold Repair procedures

Removal and Installation

1.	Remove the engine cover.

Disconnect the battery negative terminal.

Tightening torque:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft)

3.	Disconnect the front oxygen sensor connector (A) and then remove it from the bracket.

Remove the front muffler (A).

Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Remove the exhaust manifold heat protector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.	Remove the driveshaft heat protector (A).

Remove the exhaust manifold stay (A).

Tightening torque:

39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

Remove the exhaust manifold (A) with the gasket (B).

Tightening torque:

29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

When installing the exhaust manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.

Installation is reverse order of removal.

When installing, replace with a new gasket.

Exhaust Manifold Components and Components Location

Components 1. Heat protector2. Exhaust manifold gasket3. Exhaust manifold4. Exhaust manifold stay ...

Muffler Components and Components Location

Components 1. Front muffler2. Catalytic converter & center muffler assembly3. Main muffler4. Gasket5. Hanger ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Engine And Transaxle Assembly Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid misconnection. • To rele ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Checking the engine coolant level
WARNING Never remove the radiator cap or the drain plug while the engine and radiator are hot. Hot coolant and steam may blow out under pressure, causing serious injury. Turn the engine off and wait until the engine cools down. Use extreme care when removing the radiator cap. Wrap a thick ...