Hyundai Tucson: Emission control system / 2. Evaporative emission control system including Onboard Refueling Vapor Recovery (ORVR)

Hyundai Tucson (LM) 2010-2015 Owners Manual / Maintenance / Emission control system / 2. Evaporative emission control system including Onboard Refueling Vapor Recovery (ORVR)

The Evaporative Emission Control System is designed to prevent fuel vapors from escaping into the atmosphere.

The ORVR system is designed to allow the vapors from the fuel tank to be loaded into a canister while refueling at the gas station, preventing the escape of fuel vapors into the atmosphere.

Canister

Fuel vapors generated inside the fuel tank are absorbed and stored in the onboard canister. When the engine is running, the fuel vapors absorbed in the canister are drawn into the surge tank through the purge control solenoid valve.

Purge Control Solenoid Valve (PCSV)

The purge control solenoid valve is controlled by the Engine Control Module (ECM); when the engine coolant temperature is low during idling, the PCSV closes so that evaporated fuel is not taken into the engine. After the engine warms-up during ordinary driving, the PCSV opens to introduce evaporated fuel to the engine.

1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase thr ...

3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls exhaust emissions while maintaining good vehicle performance. When the engine starts or fails to start, excessive att ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications ItemsSpecificationsClutch operation methodHydraulic typeClutch cover  TypeDiaphragm spring strapClutch disc Type TypeSingle dry with diaphragmFacing diameterO235 x O155 mm ( O9.2520 x O6.1025 in.)(Outer x inner)Clutch release cylinderinner diameter20.64 mm (0.8126 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Ultrasonic Sensor Repair procedures
Removal 1. Remove the rear bumper. (Refer to the BD group - "Rear bumper") 2. Disconnect the sensor connector (A) inside the rear bumper. 3. Pull out the sensor (A) by opening the sensor holder (B) out. Installation 1. Connect the connector, and then reassemble the sensor. 2. I ...

© 2010-2024 www.htmanual.net