Inspection |
1. |
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. |
2. |
Apply a pressure of 93.16~122.58 kPa (0.95~1.25 kgf/cmx, 13.51~17.78 psi). |
3. |
Check for a drop in pressure. |
4. |
If the pressure drops, replace the cap. |
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester. |
2. |
Apply a pressure tester to the radiator and apply a pressure of 93.16~122.58 kPa (0.95~1.25 kgf/cmx, 13.51~17.78 psi). |
3. |
Inspect for engine coolant leaks and a drop in pressure. |
4. |
Remove the tester and reinstall the radiator cap.
|
Removal and Installation |
1. |
Disconnect the battery negative terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Intake and exhaust system in this group) |
3. |
Remove the under cover (A).
|
4. |
Loosen the drain plug (A), and drain the coolant.
Remove the radiator cap to speed draining.
|
5. |
Remove the radiator upper hose (A). |
6. |
Remove the radiator lower hose (A). |
7. |
Disconnect the fan motor connector (A) and then remove the cooling fan assembly.
|
8. |
Remove the front bumper.
(Refer to Body - "Front Bumper") |
9. |
Disconnect the over flow hose (A) from the radiator. |
10. |
Remove the cover (A) and the air guard (B) and then separate the condenser from the radiator. |
11. |
Remove the radiator mounting bracket (A) and then pull the radiator upper from vehicle.
|
12. |
Installation is in the reverse order of removal. |
13. |
Fill the radiator with coolant and check for leaks.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: DBC Switch Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad side switch assembly.
(Refer to Body - "Crash Pad")
3.
Check the continuity between the switch terminals as the DBC switch is engaged. ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative cable from the battery.
3.
Recover the refrigerant with a recovery/charging station.
4.
Loo ...