Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve sensor connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic system - "Valve Body") |
Hyundai Tucson (LM) 2010-2015 Service Manual: Transaxle Control Module (TCM) Description and Operation
Description
Transaxle Control Module (TCM) is the automatic
transmission's brain. The module receives and processes signals from
various sensors and implements a wide range of transmission controls to
ensure optimal driving conditions for the driver.
TCM is programmed for optim ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold.
(Refer to Engine Mechanical System - “Intake And Exhaust System”)
3.
Disconnect the knock sensor connector (A).
4.
Remove the installation bolt (B), and then r ...