Inspection |
1. |
Check signal waveform of CKPS and CMPS using a GDS.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt. |
Installation |
|
|
|
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Relay Box (Engine Compartment) Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Pull out the relay from the engine compartment relay box.
Power Relay (Type A)
Check for continuity between the terminals.
A : Blower relay
B : Horn relay
C : Cooling fan relay (Low)
D : Start relay
E : Burglar horn rela ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Temperature Control Actuator Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect the connector of temperature control actuator.
3.
Verify that the temperature control actuator operates to the
hot position when connecting 12V to the terminal 3 and grounding
terminal 4.
Verify that the temperature control actuator operate ...