Kia Sportage: Engine Coolant Temperature Sensor (ECTS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Engine Coolant Temperature Sensor (ECTS): Repair procedures

Third generation SL (20102016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS): Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification: Refer to Specification

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the engine coolant temperature sensor connector (A).

3.
Remove the spring clip (A), and then pull the sensor from the water temperature control assembly.

   
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
4.
Supplement the engine coolant (Refer to Cooling System in EM group).
Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
Apply the engine coolant to the O-ring.
   
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Engine Coolant Temperature Sensor (ECTS): Schematic Diagrams
Circuit Diagram ...

Crankshaft Position Sensor (CKPS): Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

Other Information:

Smart key precautions
If you lose your smart key, you will not be able to start the engine. Tow the vehicle, if necessary, and contact an authorized Kia dealer. A maximum of 2 smart keys can be registered to a sing ...

Immobilizer Control Unit: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the steering column assembly. (Refer to the ...

Categories

Copyright www.htmanual.net 2014-2018