Replacement |
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is
used to replace the faulty part i.e. it must be Low Line and not High
Line in order to have the correct inflation warning thresholds set. |
1. |
Disconnect vehicle battery. |
2. |
Remove the glove box.
(Refer to Body - "Crash Pad") |
3. |
Remove faulty part and fit bracket assembly to new part. |
4. |
Secure new part to vehicle and fit connector. |
5. |
Re-connect battery and turn Ignition on. |
6. |
Check that TREAD Lamp flash rate matches Virgin State indication. |
Adjustment |
Diagnosis procedure by using diagnostic device |
1. |
Connect self-diagnosis connector(16pins) located in the lower
of driver side crash pad to self-diagnosis device, and then turn the
self-diagnosis device after key is ON. |
2. |
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[Sensor ID Writing]
[Vehicle name input initialization]
[VIN input initialization] |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Battery saver function
The purpose of this feature is to prevent the battery from being discharged.
The system automatically turns off the parking lights when the engine is turned
off and the driverside door is opened (in that order).
With this feature, the parking lights will be turned off automatically if the
driv ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform
troubleshooting in accordance with the procedure for that DTC. (Refer to
DTC guide)
•
Check that the battery cables are connected to the correct termina ...