Hyundai Tucson: Starting System / Starter Components and Components Location
| Components |
| 1. Front bracket assembly 2. Magnet switch assembly 3. Lever 4. Reducer assembly 5. Lever stop | 6. Gasket sheet 7. Yoke assembly 8. Armature assembly 9. Brush holder assembly |
Starter Specifications
Specification
ItemSpecificationRated voltage12 V, 1.2 kWThe number of pinion teeth13Performance[No-load, 11 V]AmpereMax. 70 ASpeedMin. 2,400 rpm
...
Starter Schematic Diagrams
Circuit Diagram
...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold tires” means the vehicle has not been driven for at least three hours
or driven less than one mile (1.6 km).
Warm tires normally exceed recommended cold tire pressures by 4 to 6 psi (28
to 41 kPa). D ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Line Pressure Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve sensor connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
Replacing an on/off ...
