Hyundai Tucson: Starting System / Starter Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation

Description

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

1. Switch assembly
2. Yoke assembly
3. Armature
4. Over runing clutch

Troubleshooting

Troubleshooting • The battery must be in good condition and fully charged for this troubleshooting. ...

Starter Specifications

Specification ItemSpecificationRated voltage12 V, 1.2 kWThe number of pinion teeth13Performance[No-load, 11 V]AmpereMax. 70 ASpeedMin. 2,400 rpm ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Windshield Deicer Repair procedures
Inspection 1. Remove the cowl top cover. (Refer to the wiper) 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition switch ON and the windshield deicer switch ON, then mea ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Components 1. Sub frame2. Steering gearbox3. Front stabilizer bar4. Front lower arm5. Front axle6. Front strut assembly7. Drive shaft ...