Hyundai Tucson: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the VIS valve connector.

Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the variable intake solenoid valve connector (A).

3.	Disconnect the vacuum hoses (B) from the valve.

4.	Remove the installation nut, and then remove the valve from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

1.	Install in the reverse order of removal.

Variable Intake Solenoid (VIS) Valve Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Fuel Pressure Control Valve Description and Operation

Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on vario ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: AVN Head Unit Components and Components Location
Components AVN (A/V & Navigation) Head Unit Connector Connector Pin Information No.Connector AConnector BConnector C1-MM CAN High-2Parking V VIDEO--3Parking V GND--4Rear camera P groundSteering wheel remoconMTS/TMU ground5SPDIF ground-RS422 Tx +6SPDIF (+)IGNRS422 Tx -7ALT LAUX VIDEORS422 ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Making a call using the Steering wheel remote controller
1) button : Activates voice recognition. 2) button : Places and transfers calls. 3) button : Ends calls or cancels functions. Check call history and making call ➀ Shortly press (under 0.8 seconds) the key on the steering remote controller . ➁ The call history list will ...