Hyundai Tucson: Coupling Assembly / Oil hydraulic Motor(Actuator) Repair procedures

Inspection
   
If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according to the inspection process.
Oil Hydraulic Motor (Actuator) Inspection Procedure

Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - " Removal ")
2.
Keep going perpendicular state after remove the coupling assembly.
   
Keep going perpendicular state during remove (install) the hydraulic motor (actuators).

3.
Remove the hydraulic motor (A) after loosening bolts with hex wrench.
   
Remove the hydraulic motor (actuators) after dropping residual oil as much as possible inside the coupling. (abut 5~10 sec)

Installation
1.
Before installation, wipe the surface with a clean cloth.

2.
Check the O-rings (A) of the new hydraulic motor (actuators).

   
You have to prevent any dust from entering inside hydraulic motors (actuators) and housing.
3.
Tighten the bolts after install the hydraulic motor (actuators).
   
When installing, motor connector has to toward in the direction of outside of the Coupling.

Tightening torque:
8.8 ~ 10.8 N.m (0.9 ~ 1.1 kgf.m, 6.5 ~ 8.0 lb-ft)

   
When installing, oil can be reflux by the pressure in air breather hole.

Change direction in the direction of the arrow and lay on the floor as shown in the illustration.
x The reflux oil will flow to the bottom.
You have to prevent additional backflow in according to order as shown in the illustration.

4.
Wipe the flowed oil to around the surface with a clean cloth.

5.
Install the coupling assembly.
(Refer to Coupling Assembly - " Install ")
Oil hydraulic Motor(Actuator) Schematic Diagrams
Circuit Diagram ...

Pressure Sensor Description and Operation
Description The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. I ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location 1. BCM (Body Control Module)2. Smart key unit3. Start Stop Button (SSB)4. Interior antenna 15. Interior antenna 26. Trunk antenna7. Bumper antenna 8. Liftgate switch9. Door handle & door antenna10. FOB key ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Roof Trim Repair procedures
Replacement Sunvisor Replacement 1. After loosening the mounting screws, then remove the sunvisor (A) and retainer (B). 2. Install in the reverse order of removal. Assist Handle Replacement 1. Remove the covers (A), and remove the screws, then remove the assist handle (B). 2. Insta ...

© 2010-2024 www.htmanual.net