Hyundai Tucson: Engine Control System / Engine Coolant Temperature Sensor (ECTS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Remove the ECTS (Refer to "Removal").

3.	After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the engine coolant temperature sensor connector (A).

3.	Supplement the engine coolant. (Refer to Engine Control System - “Cooling System”)

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine coolant to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Engine Coolant Temperature Sensor installation :

29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)

Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Crankshaft Position Sensor (CKPS) Description and Operation

Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specification Air Conditioner ItemSpecificationCompressorTypeDVE16Oil type & CapacityPAG OIL 120±10cc (4.2±0.35 OZ.)Pulley type6PK-TYPEDisplacement160cc/revCondenserHeat rejection14,000±5% kcal/hrA/C Pressure transducerThe method to measure the pressureVoltage= 0.00878835 * Pressure (psig ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Heater & A/C Control Unit(Manual) Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper cover (A). 3. Using the screwdriver, remove the center facia lower cover (A). 4. Using the screwdriver, remove the center facia lower switch assembly (A). 5. Disconnect the connectors and ...