Inspection |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the overhead console lamp assembly.
(Refer to the BD group - "Roof trim") |
3. |
Remove the overhead console bulb (B) after disconnecting the panoramaroof switch connector and lamp connector (A). |
4. |
When replacing the bulb only, release the lens (C) cover from the roof without removing the overhead console lamp assembly. |
Installation |
1. |
Install the bulbs and connect the connectors. |
2. |
Install the overhead console lamp assembly. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the negative ...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Hazard warning flasher
The Hazard Warning Flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as possible.
The hazard warning lights are turned on and off by pushing in the hazard switch.
This c ...