Hyundai Tucson: Lighting System / Room Lamp Repair procedures

Inspection
1.
Remove the room lamp assembly connector (A) then check for continuity between terminals.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

   
Push the lens as shown arrow direction.
Take care not to damage the part (B).
3.
Loosen the fixing screw (2EA).

4.
Remove the room lamp assembly (A) after disconnecting the connector (B).

Installation
1.
Install the room lamp assembly after connecting the lamp connector.
2.
Install the lamp lens after assembling the bulb.
Head Lamps Repair procedures
Removal     Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.     The headlamp b ...

Overhead Console Lamp Repair procedures
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect th ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: 105,000 miles (168,000 km) or 84 months
Rotating tires Inspect air cleaner filter Inspect vacuum hose Inspect air conditioning refrigerant Inspect brake hoses and lines Inspect drive shafts and boots Inspect exhaust pipe and muffler Inspect front brake disc/pads, calipers Inspect propeller shaft (AWD) Inspect rear bra ...

Hyundai Tucson (LM) 2010-2015 Service Manual: High Pressure Fuel Pump Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops. 1. Turn the ignition switch OFF ...

© 2010-2024 www.htmanual.net