Brake Booster Operating Test |
1. |
Run the engine for one or two minutes, and then stop it. If
the pedal depresses fully the first time but gradually becomes higher
when depressed succeeding times, the booster is operating properly, if
the pedal height remains unchanged, the booster is inoperative. |
2. |
With the engine stopped, step on the brake pedal several times.
Then step on the brake pedal and start the engine. If the
pedal moves downward slightly, the booster is in good condition. If
there is no change, the booster is inoperative. |
3. |
With the engine running, step on the brake pedal and then
stop the engine.Hold the pedal depressed for 30 seconds. If the pedal
height does not change, the booster is in good condition, if the pedal
rises, the booster is inoperative.
If the above three tests are okay, the booster performance can be determined as good.
Even if one of the above three tests is not okay, check the check valve, vacuum hose and booster for malfunction. |
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the battery positive terminal and then remove the battery. |
3. |
Disconnect the ECM connector and then ECM and battery tray. |
4. |
Disconnect the vacuum hose (A) from the brake booster.
[LHD]
[RHD] |
5. |
Remove the master cylinder.
(Refer to Master cylinder) |
6. |
Remove the snap pin (A) and clevis pin (B). |
7. |
Remove the mounting nuts.
|
8. |
Remove the brake booster. |
Inspection |
1. |
Inspect the check valve in the vacuum hose.
|
2. |
Check the boot for damage. |
Installation |
1. |
Installation is the reverse of removal.
|
2. |
Adjust the brake pedal height and free play.
(Refer to Brake pedal height and free play adjustment) |
3. |
After installing, bleed the brake system.
(Refer to Brake system bleeding) |
Hyundai Tucson (LM) 2010-2015 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Specifications
Specification
Pressure[kPa (kgf/cmx, psi)]Output Voltage (V)20.0 (0.20, 2.9)0.7946.7 (0.47, 6.77)1.84101.3 (1.03, 14.7)4.0
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Evaporator Core Repair procedures
Replacement
1.
Remove the crash pad.
(Refer to Heater - "Heater Unit")
2.
Loosen the heater unit lower case mount screw and then remove the heater unit lower case (A).
3.
Remove the evaporator core (A).
4.
Install in the reverse order of removal. ...