Hyundai Tucson: Ignition Switch Assembly / Repair procedures
Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures
| Inspection |
| 1. |
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.
|
| 2. |
Check for continuity between the terminals. |
| 3. |
If continuity is not specified, replace the switch. |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column") |
| 3. |
Remove the ignition switch (A) after disconnecting the 6P connector (B).
|
| 4. |
Remove the key warning and immobilizer connector (A).
|
| 5. |
Remove the key illumination lens (A).
|
| 6. |
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC.
|
| Installation |
| 1. |
Install the key lock cylinder. |
| 2. |
Install the illumination bulb, lens and cover. |
| 3. |
Install the key warning and immobilizer connector. |
| 4. |
Install the ignition switch. |
| 5. |
Install the steering column shrouds and crash pad lower panel. |
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Cylinder Head Repair procedures
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine
coolant temperature drops below normal temperature (20°C [68°F])
before removin ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Replacement
Problems And Replacement Parts:
ProblemPart setScan tool requiredxAll keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YESIgnition switch does not workIgnition switch with Antenna coil unitYESUnidentified vehicle specific d ...
© 2010-2024 www.htmanual.net
