Removal |
1. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
2. |
Remove the rear seat cushion.
(Refer to Body - “Seat”) |
3. |
Remove the fuel pump service cover (A). |
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B). |
5. |
Disconnect the fuel feed tube quick connector (C). |
6. |
Remove the rear - LH wheel & tire. |
7. |
Lift the vehicle and support the fuel tank with a jack. |
8. |
Remove the center muffler assembly.
(Refer to Engine Mechanical System - “Intake And Exhaust System”) |
9. |
Remove the propeller shaft.
(Refer to Driveshaft and Axle - “Propeller Shaft Assembly”) [4WD] |
10. |
Disconnect the fuel filler hose (A) and the ventilation hose (B). |
11. |
Disconnect thd canister close valve connector (A). |
12. |
Disconnect the vapor tube quick-connector (A). |
13. |
Remove the fuel tank from the vehicle after removing the fuel tank band (A).
|
Installation |
1. |
Install in the reverse order of removal.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: Anti-lock Brake System (ABS)
WARNING
An Anti-Lock Braking System (ABS) or an Electronic Stability Control (ESC)
system will not prevent accidents due to improper or dangerous driving maneuvers.
Even though vehicle control is improved during emergency braking, always maintain
a safe distance between you and objects ahead ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Inhibitor Switch Description and Operation
Description
Inhibiter Switch contains two contact points. One of these
points connects the engine startup when the lever is in the N or P
position and turns on the reverse lights. The other contact point
monitors the lever's position (PRND) and is used to control gear setting
signals. ...