Hyundai Tucson: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Remove the rear-LH wheel, tire, and the inner wheel house.

2.	Disconnect the fuel filler hose (A) and the ventilation hose (B).

3.	Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

4.	Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).

Installation

Install in the reverse order of removal.

Filler-neck assembly bracket installation nut :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fuel Pump Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Remove the rear seat. (Refer to Body - “Seat”) ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B), th ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Clock/Calendar Setting
Clock Setting Press the key Select [Clock/Calendar] Select [Clock Settings] Use the , buttons to set the Hour, Minutes and AM/PM setting. ✽ NOTICE Press and hold the key (over 0.8 seconds) to set the Clock/Calendar screen. Calendar Setting Press the key Select [ ...

Hyundai Tucson (LM) 2010-2015 Service Manual: DBC Switch Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. (Refer to Body - "Crash Pad") 3. Check the continuity between the switch terminals as the DBC switch is engaged. ...