Hyundai Tucson: Fuel Delivery System / Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module.

Installation
1.
Install in the reverse order of removal.

Accelerator pedal module installation nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Accelerator pedal module installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly Repair procedures
Removal 1. Remove the rear-LH wheel, tire, and the inner wheel house. 2. Disconnect the fuel filler hose (A) and the ventilation hose (B). 3. Open the fuel filler door and unfasten the fil ...

Delivery Pipe Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Body Control Module (BCM) Components and Components Location
Components Connector Pin Information NoConnector AConnector BConnector CConnector D1B+LIN (RPAS)Safety power window Enable lowRear seat heater relay2IGN 1Head lamp low switchSecurity INDRear fog lamp relay3IGN 2Head lamp high switchAV unlock signalFront wiper relay4Turn signal switch (LH)Auto ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Trailer towing
If you are considering to tow with your vehicle, you should first check with your state's Department of Motor Vehicles to determine legal requirements. Since laws vary from state to state the requirements for towing trailers, vehicles, or other types of vehicles or apparatus may differ. Ask an ...

© 2010-2024 www.htmanual.net