Removal |
|
1. |
Remove the following parts
|
2. |
Loosen the quarter fixed glass (A) mounting nut. |
3. |
Cut out the quarter fixed glass sealant using the utility knife.
|
4. |
Remove the quarter fixed glass. |
Installation |
1. |
With a putt knife, scrape the old adhesive smooth to a
thickness of about 2mm (0.08 in.) on the bonding surface around the
entire quarter fixed glass flange.
|
2. |
Clean the body bonding surface with a sponge dampened in
alcohol. After cleaning, keep oil, grease and water from getting on the
surface. |
3. |
With a sponge, apply a light coat of glass primer along the
edge of the quarter fixed glass as shown, then lightly wipe it off with
gauze or cheese cloth :
|
4. |
With a sponge, apply a light coat of body primer to the
original adhesive remaining around the flange. Let the body primer dry
for at least 10 minutes.
|
5. |
Pack adhesive into the cartridge without air pockets to
ensure continuous delivery. Put the cartridge in a caulking gun, and run
a bead of sealant around the edge of the quarter fixed glass (A) as
shown. Apply the adhesive within 30 minutes after applying the glass
primer. Make a slightly thicker bead at each corner. |
6. |
Install the quarter fixed glass. |
7. |
Let the adhesive dry for at least one hour, then spray water
over the quarter fixed glass and check for leaks. If a leak occurs, let
it dry, then seal with sealant :
|
8. |
Reinstall all remaining removed parts. |
9. |
Installation the following items.
|
Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Components
1. Steering wheel2. Steering column3. ECU4. Motor5. Steering gear box
...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Operating door locks from inside the vehicle
With the door lock button:
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the door lock button will be visible.
To lock a door, push the door lock button (1) to the “Lock” position. If
the door is locked properly, the red mark (2) ...