Hyundai Tucson: Bumper / Front Bumper Repair procedures

Replacement
   
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover mounting bolts and clips.

2.
Remove the mounting clips.

3.
After loosening the front bumper side’s mounting screw and clip, then disconnect the side’s.

4.
Push the lock pin, disconnect the fog lamp connector (A).
5.
Remove the front bumper.

6.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damage clips.
Front Bumper Components and Components Location
Components 1. Front bumper assembly2. Front bumper rail ...

Rear Bumper Components and Components Location
Components 1. Rear bumper assembly2. Rear bumper mounting bracket ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal     Replacing an on/off soleno ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting ProblemPossible causeSolutionNot pairingBluetooth device of Car is not discoverable modeEnter Bluetooth pairing (searching) modeUser’s phone is Bluetooth off modeUser’s phone set Bluetooth onMaking an attempt pairing others bluetooth systemCheck Bluetooth device name and add ...

© 2010-2024 www.htmanual.net