Hyundai Tucson: General Information / Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Mechanical System / General Information / Repair procedures

Compression Pressure Inspection

If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.

1.	Warm up and stop engine. Allow the engine to warm up to normal operating temperature.

2.	Disconnect the injector extension connector (A).

3.	Disconnect the ignition coil connectors (A).

4.	Remove ignition coils (A).

5.	Remove spark plugs (A). Using a 16mm plug wrench, remove the 4 spark plugs.

Check cylinder compression pressure.

(1)	Insert a compression gauge into the spark plug hole.

(2)	Fully open the throttle.

(3)

While cranking the engine, measure the compression pressure.

Always use a fully charged battery to obtain engine speed of 200 rpm or more.

(4)

Repeat steps (1) through (3) for each cylinder.

This measurement must be done in as short a time as possible.

Compression pressure:

1,373 kPa (14.0 kgf/cmx, 199 psi)

Minimum pressure:

1,226 kPa (1.25 kgf/cmx, 178 psi)

Difference between each cylinder:

100 kPa (1.0 kgf/cmx, 15 psi) or less

(5)

If the cylinder compression in 1 or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat steps (1) through (3) for cylinders with low compression.

A.	If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.

B.	If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket.

Reinstall spark plugs.

Tightening torque:

14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.8 ~ 18.1 lb-ft)

Install ignition coils.

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

9.	Connect the injector connectors and ignition coil connectors.

10.	Some DTCs may exist after the inspection test and may need to be manually cleared with GDS.

Specifications

Specifications DescriptionSpecificationsLimitGeneralTypeIn-line, DOHCxNumber of cylinders4xBore81.0 mm (3.1890 in.)xStroke97.0 mm (3.8189 in.)xTotal displacement1999 cc (121.99 cu.in.)xCompressio ...

Troubleshooting

Troubleshooting SymptionSuspect areaRemedyEngine misfire with abnormal internal lower engine noises • Worn crankshaft bearings • Loose or out of specification engine flywheel � ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Using Bluetooth® Wireless Technology Audio Mode
Playing/Pausing Bluetooth® Wireless Technology Audio Once a Bluetooth® Wireless Technology device is connected, the mode will automatically start. While playing, press the button to pause and press button to play. ✽ NOTICE The play/pause feature may operate differently ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Intake Air Temperature Sensor (IATS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1. Turn the ignition swit ...