Inspection |
1. |
With the fog lamp switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the multifunction switch. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper.
(Refer to the BD group - "Front bumper") |
3. |
Remove the front fog lamp (A) by turning in the counterclockwise direction after disconnecting the connector. |
4. |
Remove the front fog lamp (A) after loosening the screws. |
Installation |
1. |
Install the front fog lamp bulb. |
2. |
Connect the front fog lamp connector. |
3. |
Install the front bumper. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting
ProblemPossible causeSolutionNot pairingBluetooth device of Car is not discoverable modeEnter Bluetooth pairing (searching) modeUser’s phone is Bluetooth off modeUser’s phone set Bluetooth onMaking an attempt pairing others bluetooth systemCheck Bluetooth device name and add ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Antenna Repair procedures
Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable.
3.
Check for continuity between the outer poles of antenna cable. There should be continuity.
4.
If there is no continuity, replace ...