Hyundai Tucson: ESC(Electronic stability system) System / Steering Angle Sensor Description and Operation
The Steering Angle Sensor (SAS) is installed in EPS (Electric
Power Steering) and it sends messages to HECU through CAN communication
line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESP-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe
relay, etc.) of the EPS system are located inside the steering column
& EPS unit assembly and the steering column & EPS unit assembly
must not be disassemble to inspect or replace them.
(Refer to “ST (Steering system) Gr”)
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad side switch assembly.
(Refer to Body - "Crash Pad")
3.
Check the continuity b ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Heater Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
3.
When the engine is cool, drain the engine coolant from the radiator.
4.
Remove the expansion valve cover (A).
5.
Remove the bolts (A) and t ...
Hyundai Tucson (LM) 2010-2015 Owners Manual: Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 (or 3) fuse panels, one located in the driver’s side panel
bolster, the other in the engine compartment near the battery.
If any of your vehicle’s lights, accessories, or controls do ...