Hyundai Tucson: Lighting System / Rheostat Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Lighting System / Rheostat Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to the BD group - "Crash pad")

Remove the crash pad side switch assembly (A) as shown below picture.

Put on gloves to protect your hands.

Remove the rheostat switch (A) after disconnecting the connectors.

Take care not to damage the hook when removing the rheostat switch.

5.	Operate the switch and check for continuity between terminals with an ohmmeter.

Hazard Lamp Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit") 3. Disconnect the hazard lamp switch conne ...

Front Fog Lamps Repair procedures

Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit. (Refer to Heater - "Heater Unit") 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air ...

Hyundai Tucson (LM) 2010-2015 Service Manual: DBC Switch Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. (Refer to Body - "Crash Pad") 3. Check the continuity between the switch terminals as the DBC switch is engaged. ...