Kia Sportage: Knock Sensor (KS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Knock Sensor (KS): Repair procedures

Third generation SL (2010Ц2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS): Repair procedures

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the intake manifold (Refer to УIntake And Exhaust SystemФ in EM group).
Disconnect the knock sensor connector (A).
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Installation is reverse of removal.

Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS): Schematic Diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S): Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

Other Information:

Heater & A/C Control Unit(Full Automatic): Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setu ...

Transaxle Oil Temperature Sensor: Description and Operation
Description Transaxle oil temperature sensor monitors the automatic transaxle fluid''s temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resi ...


Copyright © 2014-2018