Removal |
1. |
Drain the brake fluid through the bleed plug (A). |
2. |
Remove the clutch release cylinder assembly (C) after removing thd tube (B) and bolts (A-2ea). |
Installation |
1. |
Installation is the reverse of removal.
|
Adjustment |
Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands of fluid. |
Specified fluid: SAE J1703 (DOT 3 or DOT 4) |
1. |
After disconnecting a cap from the clutch release cylinder air bleeder, insert a vinyl hose in the plug. |
2. |
Loosening the plug screw, press and release the clutch pedal about 10 times. |
3. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards, raise the pedal with a hand. |
4. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and retighten it with the pedal pressed. Raise it again, then. |
5. |
Repeat the step 4 two or three times. (until there is no bubble in the fluid)
|
6. |
Refill the clutch master cylinder with the specified fluid. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Canister Repair procedures
Removal
1.
Remove the fuel tank.
(Refer to "Fuel tank" in FL group.)
2.
Disconnect the vapor tube quick-connector (A,B) and the ventilation hose (C).
3.
Remove the canister in the direction of an arrow after removing the installation screws (D).
Inspection
1.
Check for the follow ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Thermostat Troubleshooting
Troubleshooting
SymptomsPossible CausesRemedyCoolant leakage
•
From the thermostat gasket
Check the mounting bolts
•
Check the torque of the mounting bolts
•
Retighten the bolts and check leakage again.
Check the gasket for damage
•
Check gasket or seal for damage
...