Hyundai Tucson: Front Suspension System / Front Strut Assembly Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Suspension System / Front Suspension System / Front Strut Assembly Repair procedures

Replacement

Remove the front wheel & tire.

Tightening torque :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire.

2.	Remove the brake hose (A) & wheel speed sensor bracket (B) from the front strut assembly by loosening mounting bolts.

Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.

Tightening torque :

98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

Disconnect the front strut assembly (A) with the knuckle by loosening the bolt & nut.

Tightening torque :

137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

Remove the front strut assembly and than loosen the strut mounting nuts (A).

Tightening torque :

44.1 ~ 58.8N.m (4.5 ~ 6.0kgf.m, 32.5 ~ 43.4lb-ft)

6.	Installation is the reverse of removal.

Disassembly

1.	Remove the dust cover (A).

2.	Using the special tool (09546-26000), compress the coil spring (A).

3.	Remove the self-locking nut (C) from the strut assembly (B).

4.	Remove the insulator, spring seat, coil spring and dust cover from the strut assembly.

5.	Reassembly is the reverse of the disassembly.

Inspection

1.	Check the strut bearing for wear and damage.

2.	Check the spring upper and lower seat for damage and deterioration.

3.	Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal

1.	Fully extend the piston rod.

Drill a hole on the A section to remove gas from the cylinder.

The gas coming out is harmless, but be careful of chips that may fly when drilling.

Be sure to wear safety goggles or eye protection when performing this task.

Front Strut Assembly Components and Components Location

Components 1. Dust cover2. Upper mounting nut3. Self locking nut4. Insulator5. Spring upper pad6. Strut dust cover & Bumper rubber7. Coil spring8. Spring lower pad9. Piston rod10. Strut asse ...

Front Lower Arm Repair procedures

Removal 1. Remove the front wheel & tire. Tightening torque : 88.25 ~ 117.68 N.m (9.0 ~ 12.0 kgf.m, 65.1 ~ 86.8 lb-ft) Be careful not to damage to the hub bolts w ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manif ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Audio Unit Components and Components Location
Components Connector Pin Information No.Connector AConnector B1Rear left speaker (+)CAN High2Front left speaker (+)-3Front right speaker (+)-4Rear right speaker (+)Steering wheel remote5--6-USB D (+)7IgnitionUSB/iPod VDD8Illumination (+)AUX R IN9DetentAUX GND10Rear left speaker (-)Mic (+) B/T11F ...