Warning Lamp Activation |
Warning Lamp Behavior after Ignition On |
1. |
Active fault. |
2. |
Normal or historical faults only exist. |
3. |
When turning the ignition switch ON during variant coding
(EOL) mode, the airbag warning lamp is turned on and blinks at intervals
of 1 second till the coding is completed.
In case the variant coding is normally completed, the airbag
warning lamp is turned on for 6 seconds, and then turned off. Otherwise
the airbag warning lamp continuously blinks at intervals of 1 second.
When there is active fault in airbag system or SRSCM internal
fault, the variant coding (EOL) can’t be completed. In this case, do
the variant coding (EOL) procedure again after troubleshooting with the
GDS. |
1. |
Loss of battery supply to the SRSCM : warning lamp turned on continuously. |
2. |
Loss of internal operating voltage : warning lamp turned on continuously. |
3. |
Loss of Microprocessor operation : warning lamp turned on continuously. |
4. |
SRSCM not connected : warning lamp turned on continuously.
|
Hyundai Tucson (LM) 2010-2015 Owners Manual: Automatic heating and air conditioning
When using the AUTO climate control mode, the fan speeds, mode selection, air
intake control, and the air conditioning will be automatically controlled according
to the desired temperature setting.
To enable this mode, perform the following steps:
1. Push the AUTO button.
2. Set the t ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Evaporator Temperature Sensor Repair procedures
Inspection
1.
Ignition "OFF".
2.
Disconnect evaporator temperature sensor.
3.
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Specification
Evaporator core temperature [°C (°F)]Resistance[Kx]-10 (14)18.010 (32)11.3810 (50)7.3 ...