Hyundai Tucson: Rear Suspension System / Rear Assist Arm Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Suspension System / Rear Suspension System / Rear Assist Arm Repair procedures

Replacement

Remove the rear wheel & tire.

Tightening torque :

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the rear wheel & tire.

Remove the sprit pin and castle nut or bolt and then disconnect the rear assist arm (A) from the rear axle.

Tightening torque :

2WD

44.1 ~ 53.9N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

4WD

137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

[2WD]

[4WD]

Loosen the bolt & nut and then remove the rear assist arm (A) with the sub frame.

Tightening torque :

107.9 ~ 117.7N.m (11.0 ~ 12.0kgf.m, 79.6 ~ 86.8lb-ft)

[2WD]

[4WD]

4.	Installation is the reverse of removal.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the rear assist arm for deformation.

3.	Check ball joint for damage.

4.	Check for the all bolts and nuts.

Rear Stabilizer Bar Repair procedures

Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when ...

Trailing Arm Repair procedures

Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) Be careful not to damage to the hub bolts w ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Driveshaft Components and Components Location
Components 1. Tone wheel2. BJ joint3. BJ boot4. BJ boot big part band5. BJ boot small part band6. Shaft7. TJ boot small part band8. TJ boot big part band9. TJ boot10. Snap ring11. Circlip12. TJ assembly ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Shift Cable Repair procedures
Removal 1. Remove the console. (Refer to Body - "Floor console") 2. Disconnect the shift cable (A) from the shift lever. 3. Remove the shift cable assembly in the vehicle after removing the nuts (B) and the retainer (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...