Hyundai Tucson: Driveshaft Assembly / TJ Joint Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Repair procedures

Removal

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

1.	Remove the Front Driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the housing circlip (B) from the driveshaft spline (A).

3.	Remove both boot bands from the TJ housing.

Remove the TJ housing (A).

Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.

5.	Remove the retainer ring (A) from the shaft.

6.	Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).

7.	Clean the spider assembly.

Remove the TJ boot (A).

For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).

Inspection

1.	Check the spider assembly for roller rotation, wear or corrosion.

2.	Check the groove inside the joint case for wear or corrosion

3.	Check the TJ boots for damage and deterioration.

Installation

1.	Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot.

2.	Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and retainer ring (B) on the driveshaft splines (C).

3.	Add specified grease to the joint boot as much as it was wiped away at inspection.

4.	Install the both boot band.

Using the SST(09495-3K000), secure the TJ boot bands.

Clearance (A) : 2.0 mm (0.0787 in.) or less

6.	Install the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

7.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

TJ Joint Components and Components Location

Components [LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft6. TJ boot band7. TJ boot8. Spider assembly9. Retainer ring10. TJ housing11. Housing circlip [RH] 1. BJ ...

Dynamic Damper Components and Components Location

Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications DescriptionSpecificationsLimitGeneralTypeIn-line, DOHCxNumber of cylinders4xBore81.0 mm (3.1890 in.)xStroke97.0 mm (3.8189 in.)xTotal displacement1999 cc (121.99 cu.in.)xCompression ratio11.5±0.2 : 1xFiring order1-3-4-2xValve timingIntake valveOpenATDC 10° ~ BTDC 40°xCloseABDC ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Child restraint system
WARNING Always properly restrain children in the rear seats of the vehicle. Children of all ages are safer when restrained in the rear seat. A child riding in the front passenger seat can be forcefully struck by an inflating air bag resulting in SERIOUS INJURY or DEATH. Children under age 13 ...