Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
4. |
If they are abnormal, replace the washer motor.
|
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper cover.
(Refer to the BD group - "Front bumper") |
3. |
Remove the washer hose (A) and disconnect the washer motor connector (B). |
4. |
Remove the front washer motor (A). |
5. |
Remove the rear washer motor (A). |
6. |
Remove the washer reservoir (B) after removing bolts (A). |
Installation |
1. |
Reassemble the washer reservoir.
|
2. |
Connect the washer motor connectors and washer hoses. |
3. |
Install the front and rear washer motor. |
4. |
Install the front and rear washer nozzle.
|
5. |
Install the front bumper cover. |
Hyundai Tucson (LM) 2010-2015 Owners Manual: Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle o ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Thermostat Repair procedures
Removal and Installation
Disassembly of the thermostat would have an adverse effect,
causing a lowering of cooling efficiency. Do not remove the thermostat,
even if the engine tends to overheat.
1.
Drain engine coolant so its level is below thermostat.
2.
Disconn ...