Hyundai Tucson: Bumper / Rear Bumper Repair procedures

Replacement
   
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting screws, then remove the rear combination lamp (A).

2.
Push the lock pin, disconnect the connector (A).

3.
After loosening the rear bumper side's mounting screw and clips, then disconnect the side's.

4.
Loosen the mounting bolts.
5.
Push the lock pin, disconnect the rear bumper main connector (B).

6.
After loosening the mounting screws and clips, then remove the rear bumper (A).

7.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damage clips.
Rear Bumper Components and Components Location
Components 1. Rear bumper assembly2. Rear bumper mounting bracket ...

Seat & Power Seat
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: 60,000 miles (96,000 km) or 48 months
Rotating tires Inspect vacuum hose Inspect air conditioning refrigerant Inspect brake hoses and lines Inspect drive shafts and boots Inspect exhaust pipe and muffler Inspect front brake disc/pads, calipers Inspect propeller shaft (AWD) Inspect rear brake disc/pads Inspect steeri ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Luggage Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver 3. Remove the luggage room lamp bulb in case of necessity Installation 1. Replace the lamp bulb. 2. Install the luggage room lamp asse ...

© 2010-2024 www.htmanual.net