Hyundai Tucson: Seat Belt / Front Seat Belt Repair procedures

Replacement
Front Seat Belt Replacement [General]
   
When installing the belt, make sure not to damaged the pretensioner.
1.
Remove the following items first :
A.
Front door scuff trim
(Refer to Interior - "Interior Trim")
B.
Rear door scuff trim
(Refer to Interior - "Interior Trim")
2.
After raise the lower anchor cover (A), loosen the lower anchor (B) mounting bolt.

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

3.
Remove the center lower pillar trim (A).

4.
Remove the cap.
5.
After loosening the mounting bolt, then remove the center upper pillar trim (A) .

6.
After loosening the mounting bolt, then remove the upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

7.
After disconnecting the pretensioner connector lock pin, remove the pretensioner connector (B), loosen the mounting bolt, then remove the pretensioner (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

8.
Install in the reverse order of removal.
Front Seat Belt Replacement [Europe]
   
When installing the belt, make sure not to damaged the pretensioner.
1.
Remove the following items first :
A.
Front door scuff trim
(Refer to Interior - "Interior Trim")
B.
Rear door scuff trim
(Refer to Interior - "Interior Trim")
2.
Using a screwdriver or remover (B), remove the lower anchor (A).

3.
Remove the center lower pillar trim (A).

4.
Remove the cap.
5.
After loosening the mounting bolt, then remove the center upper pillar trim (A) .

6.
After loosening the mounting bolt, then remove the upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

7.
After disconnecting the pretensioner connector lock pin, remove the pretensioner connector (B), loosen the mounting bolt, then remove the pretensioner (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

8.
Install in the reverse order of removal.
Height Adjust Relacement
1.
Remove the following items first :
A.
Front door scuff trim
(Refer to Interior - "Interior Trim")
B.
Rear door scuff trim
(Refer to Interior - "Interior Trim")
C.
Front seat belt lower anchor
D.
Front seat belt upper anchor
E.
Center lower pillar trim
(Refer to Interior - "Interior Trim")
F.
Center upper fillar trim
(Refer to Interior - "Interior Trim")
2.
After loosening the mounting bolt, then remove the hight adjustor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft )

3.
Install in the reverse order of removal.
   
Replace ant damaged clips.
Make sure the height adjust properly.
Front Seat Belt Buckle Relacement
1.
Remove the front seat.
(Refer to Seat & Power Seat - "Front Seat")
2.
After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Install in the reverse order of removal.
Components and Components Location
Components 1. Front seat belt2. Height adjuster3. Rear seat belt4. Rear center seat belt buckle ...

Rear Seat Belt Repair procedures
Replacement Secondary Seat Belt Relacement     • When installing the belt, make sure not to damaged the retractor. 1. Remove the rear seat. (Refer to Seat & Power ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Emergency precautions
Tires Do not use tire and wheel with different size and type from the one originally installed on your vehicle. It can affect the safety and performance of your vehicle, which could lead to steering failure or rollover causing serious injury. When replacing the tires, be sure to equip all four ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Component Location 1. Hood switch2. Burglar horn3. BCM & RF receiver4. Key warning switch5. Front door switch6. Front door lock actuator & switch7. Rear door lock actuator & switch8. Rear door switch9. Liftgate lid switch 1. Antenna2. BCM connector3. Antenna bracket ...

© 2010-2024 www.htmanual.net