Hyundai Tucson: Engine Control System / Knock Sensor (KS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold. (Refer to Engine Mechanical System - “Intake And Exhaust System”)

3.	Disconnect the knock sensor connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Install in the reverse order of removal.

Knock sensor installation bolt:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Heated Oxygen Sensor (HO2S) Description and Operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Radio : FM, AM OR XM
Seek Press the key Shortly pressing the key (under 0.8 seconds): Changes the frequency. Pressing and holding the key (over 0.8 seconds): Automatically searches for the next frequency. Preset Seek Press the ~ key Shortly pressing the key (under 0.8 seconds): ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Power adjustment
The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel. WARNING NEVER allow children in ...