Hyundai Tucson: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.

(Refer to Hydraulic system - "Valve Body")

26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams

Circuit Diagram ...

Line Pressure Control Solenoid Valve Description and Operation

Description line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Blade replacement
Front windshield wiper blade ■ Type A 1. Raise the wiper arm and slightly rotate the wiper blade assembly to expose the plastic locking clip. CAUTION Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield. 2. Press the clip (1) and slide ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Low tire pressure indicator
The low tire pressure indicator comes on for 3 seconds after the ignition switch is turned to the "ON" position. The low tire pressure indicator illuminates when one or more of your tires is significantly underinflated. The low tire pressure indicator will illuminate after it blinks for appr ...