Hyundai Tucson: Audio / Audio Remote Control Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Audio / Audio Remote Control Repair procedures

Inspection

Check for resistance between No.6 and No.7 terminals in each switch position.

[Audio System]

Switch	Connector terminal	Resistance (±5%)
Volume down	6 - 7	6.81 kx
Volume up	6 - 7	4.61 kx
Mute	6 - 7	3.11 kx
Mode	6 - 7	2.11 kx
Seek down	6 - 7	1.11 kx
Seek up	6 - 7	430 x

Check for voltage between No.6 and No.7 terminal in each switch position.

[Audio System]

Switch	Connector terminal	Output voltage
Volume down	6 - 7	1.95 ± 0.16 V
Volume up	6 - 7	1.63 ± 0.16 V
Mute	6 - 7	1.31 ± 0.16 V
Mode	6 - 7	1.02 ± 0.16 V
Seek down	6 - 7	0.63 ± 0.16 V
Seek up	6 - 7	0.28 ± 0.16 V

Removal

1.	Remove the driver airbag module. (Refer to the RT group - "Airbag module")

2.	Remove the steering wheel screws from the back cover.

3.	Disconnect the audio remote control switch connector (A).

Remove the audio remote control switch (A).

Be careful not to damage the hook when removing the switch.

Installation

1.	Install the audio remote control switch on the steering wheel.

2.	Install the steering wheel.

Reconnect the audio remote control switch connector and airbag connectors.

Make sure that the switch connector is plugged in properly.

Install the driver airbag module.

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Make sure horn button works.

Audio Remote Control Schematic Diagrams

Circuit Diagram ...

AUX(Auxiliary) Jack Schematic Diagrams

Circuit Diagram ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Emergency precautions
Tires Do not use tire and wheel with different size and type from the one originally installed on your vehicle. It can affect the safety and performance of your vehicle, which could lead to steering failure or rollover causing serious injury. When replacing the tires, be sure to equip all four ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, wa ...