Inspection |
1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
2. |
Are the fuse capacities for each circuit correctx |
3. |
Are there any blown fusesx
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
Inspection |
1. |
The SJB can be diagnosed by using the GDS. The SJB
communicates with the GDS which then displays inputs and outputs along
with codes. |
2. |
To diagnose the SJB function, select the vehicle model, BCM and SJB. |
3. |
To consult the present input/out value of SJB, "Current DATA". It provides information of SJB input/output conditions. |
4. |
To perform functional test on SJB outputs, select "Actuation Test" |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
3. |
Remove the SJB (A) (Smart Junction Box) after removing bolt, nuts and connectors. |
Installation |
1. |
Install SJB (Smart Junction Box). |
2. |
Connect the SJB connectors. |
3. |
Install the crash pad lower panel. |
Hyundai Tucson (LM) 2010-2015 Service Manual: Side Airbag (SAB) Module Description and Operation
Description
The Side Airbags (SAB) are installed inside the front seat
and protects the driver and passenger from danger when side crash
occurs. The SRSCM determines deployment of side airbag by using Side
Impact Sensor (SIS) signal.
Never attempt to measure the circu ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
20 ~ 25 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.2 lb-ft)
2.
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and cl ...