Hyundai Tucson: Air Conditioning System / Ambient Sensor Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Ambient Sensor Repair procedures

Inspection

1.	Ignition "OFF"

2.	Disconnect ambient temperature sensor.

Check the resistance of ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature.

1. Sensor Ground

2. Ambient Sensor Signal

Specification

Ambient temperature [°C(°F)]	Resistance between terminals 1and 2 (kx)
-30(-22)	479.22
-20(-4)	271.45
-10(14)	158.32
0 (32)	95.10
10 (50)	58.76
20 (68)	37.30
30(86)	24.27
40(104)	16.17
50(122)	11.00

4.	If the measured resistance is not specification, substitute with a known-good ambient temperature sensor and check for proper operation.

5.	If the problem is corrected, replace the ambient temperature sensor.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector and then remove the ambient temperature sensor (A).

3.	Install in the reverse order of removal.

Ambient Sensor Description and Operation

Description 1. The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lowe ...

Cluster Ion Generator Components and Components Location

Component Location ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Rear window wiper and washer
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. ON - Normal wiper operation INT - Intermittent wiper operation (if equipped) OFF - Wiper is not in operation ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Delivery Pipe Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops. 1. Turn the ignition switch OFF ...