Removal |
1. |
Turm ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the battery positive terminal and them remove the battery. |
3. |
Disconnect the ECM connector and the ECM and battery tray. |
4. |
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
[LHD]
[RHD] |
5. |
Remove the brake fluid from the master cylinder reservoir with a syringe.
|
6. |
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
[LHD]
[RHD] |
7. |
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).
[LHD
[RHD |
Installation |
1. |
Installation is the reverse of removal. |
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding) |
Hyundai Tucson (LM) 2010-2015 Service Manual: Front Strut Assembly Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Remove the brake hose (A) & wheel speed sens ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Thermostat Repair procedures
Removal and Installation
Disassembly of the thermostat would have an adverse effect,
causing a lowering of cooling efficiency. Do not remove the thermostat,
even if the engine tends to overheat.
1.
Drain engine coolant so its level is below thermostat.
2.
Disconn ...